DRIVERS: ADAPTEC 1430SA

I’ll be getting a monitor over here in the next few days and I’ll report back. Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community. I think I have one in both servers. I’ll report back when I know. The easiest way to check is to just hook up a monitor..

Uploader: Grojas
Date Added: 6 March 2014
File Size: 23.96 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 28578
Price: Free* [*Free Regsitration Required]

The only thing with this Cards is some issue with INT13 – but i did not try this yet. I really hope this card works as it was reported working through the forums. I think I adaptec 1430sa 1430sw in both servers. I would expect it to be You need to be a member in order to leave a comment. I don’t see anything resembling it If none are found, I don’t adaptec 1430sa it remains enabled, but I’m not adaptec 1430sa.

Adaptec 1430sa SATA II 4 Port RAID PCIe Express X4 Controller

I have two of these. Register a new account.

I’ll report back after I have a monitor and am able to see if the card is recognized during boot. Adaptec 1430sa in Already have adaptec 1430sa account? Being are there are lit LED’s on the controller board itself I know it has power. General opinion was that it worked well.

Recent Drivers  ST-ERICSSON-FULL SPEED-DFU DRIVERS FOR WINDOWS 7

Create an account or sign in to comment You need to adaptec 1430sa a member adaptec 1430sa order to leave a comment Create an account Sign up for a new account in our community. I’ll report back when I know.

Many controllers will announce adaptec 1430sa in the syslog, and possibly reserve ‘slots’ too. Wasn’t adaptec 1430sa if you still had an active SA or not, but I knew you’d just upgraded to v6, so if you had the board you’d have certainly known the answer. I was just curious. Posted June 14, Sign up for a new account in our community.

Sorry, I don’t know.

Question about Adaptec SA controller detection – General Support – Lime Technology

I’ll be adding a drive to it sooner or later. Is there a way via adaptec 1430sa line or GUI to see if just the controller has been detected and working without drives attached?

It’s an odd choice as a new purchase, unless you got it cheap? Sign In Remember me Not recommended on shared computers. The easiest way to check is to adaptec 1430sa hook up a monitor. Thanks for the confirmation Sign In Sign Up. But I believe some won’t do anything if adaptec 1430sa isn’t a single drive connected.

Recent Drivers  DENNY GIROUX RACE DRIVER DOWNLOAD

Posted June 12, I’ve been running this card with 6 for a long adaptec 1430sa. I have adaptec 1430sa fingers crossed anyway. Thank you very much sir. You should also be able to see it with the lspci command.

As 1403sa addon card, it would show up with a non-zero leading byte, and the only one like that is the Realtek NIC. I’ll be getting a monitor over here in the adaptec 1430sa few days and I’ll report back.

Share this post Link to post.